阿羅丁處理
•阿羅丁1200S溶液的配製
Alodine 1200S Solution Preparation
•(1) Prepare the brush chemical conversion coating solution.
準備刷塗用溶液。
NOTE: Prepare the solution in small quantities. A solution that is not used in 24 hours is not usable and should be thrown away. A dirty solution is unsatisfactory.
要少量配製。24小時內沒有用完的溶液不能再使用,應該丟棄。被污染的溶液不能使用。
•(2) Mix 3 ounces of Alodine 1200S powder and 1 gallon of deionized or distilled water in apolyethylene,stainless steel container.
使用聚乙烯或不鏽鋼容器。每1加侖水加入3盎司阿羅丁1200S。
(1加侖水如果是美製就是3.79千克、1盎司=28.350克 即100:2.25)
您好,很高興為您解答。阿洛丁1200s化學轉膜後是其表面形成一層從淺金色到棕黃色的
常用的阿洛丁溶液及其使用注意事項:根據鋁合金材料類型、底漆、顏色要求的不同,常用的阿洛丁溶液包括:阿洛丁 600,處理後鋁合金表面呈黃色阿洛丁1200、 1200S、 1201,處理後鋁合金表面呈淺金色到棕黃色阿洛丁 1000、 1000L、 1001、1500,處理後保持鋁合金本色.
通常阿洛丁在銷售時是按粉狀包裝的,在使用前,需要對其調配成一定濃度的酸性水溶液(1加倫水加3盎司阿洛丁600粉),並靜置至少一個小時後才能塗用。